Status Indicators; Rgb Led; Alphanumerical Display - Gewiss JOINON Mode D'emploi

Gewiss

9. Status indicators

Depending on the operating modes available on the model purchased, the recharging station will have at least one tool for informing the
client about the status and the actions to be carried out.

9.1. RGB LED

The recharging station has 2 RGB LEDs, one for each side and socket-outlet. Their colour changes to inform the client about the status
of the station and the actions that need to be carried out. The colour change may be on one side only or on both, depending on the
situation.
Light
Fixed green
Flashing green
Fixed blue
Flashing blue
Fixed red
None

9.2. Alphanumerical display

Each socket-outlet has a display showing various items of information that help the client understand the station status and the actions
required.
Words on the display
SWIPE THE CARD
TO RECHARGE
CARD ENABLED
*PLEASE WAIT*
*ATTENTION*
CARD NOT VALID
CARD ENABLED
CONNECT THE CABLE
RECHARGE IN PROGRESS
Ts=0000 Tc=0000
RECHARGE IN PROGRESS
kW=00.00 kWh=00.00
RECHARGE TERMINATED
REMOVE THE CABLE
SESSION SUMMARY
Ts=0000 Tc=0000
SESSION SUMMARY
kW=00.00 kWh=00.00
OUT OF SERVICE
DUE TO TECHNICAL PROBLEMS
Words on the display
*SAVING*
SWIPE THE CARDS
62
The station is ready to begin a recharging session (no problems found).
The station is waiting for the charging plug to be connected, and the connection with
the car
or
The station is waiting for the charging cable to be removed (disconnecting the car and
thereby ending the charging session).
The charging session is in progress and the car is absorbing energy.
The charging session is in progress but the car is not absorbing energy (recharged
terminated, or the car is not ready for recharging).
The station has detected an internal error or an error in the connection with the car,
and cannot continue the recharging process.
The station does not have the necessary electrical power supply.
CHARGING PROCESS
In RFID mode, the station waits for an RFID card, checks it is valid, and then
begins the recharging process.
The RFID card has been recognised by the system.
The RFID card has not been recognised, so the recharging session cannot be
started.
The station is waiting for the charging plug to be connected, and the connection
with the car.
The session is in progress and the display shows the stationary time (Ts) and the
charging time (Tc).
The session is in progress and the display shows the power dispensed (kW) and
the energy absorbed by the car (kWh)
The session has ended and the station is waiting for the cable to be removed.
When the cable is removed, the station shows a summary of the session that has
just ended.
When the cable is removed, the station shows a summary of the session that has
just ended.
The session cannot be started/continued because of an error, so it is ended.
LOCAL RFID CARD CONTROL
Once the MASTER card has been swiped, the station goes into acquisition mode.
Swipe one RFID card at a time so it can be read and added to the local White List.
Description
Description
Description
7.55.4.502.0 - Installation and Operation Manual
Status indicators