Updating The Firmware - Gewiss JOINON Mode D'emploi

Updating the firmware

12. Updating the firmware
Recharging stations not designed for remote connection to the cloud platform can be updated by inserting the SD card in the relative
slot of the electronic card.
To understand which firmware version is installed in the device, just switch the station off and then back on again; the display will show
the version.
To update the firmware, proceed as follows:
#
1 Disconnect the power supply to the product by means of the main device
2 Remove the SD card from the relative slot on the electronic card
3 Insert the SD card in the specific slot of your PC to open the folder
Paste the update file in the main folder of the SD card
4
NB: contact GEWISS SAT Customer Service for the most recent file
5 Put the SD card back in the slot on the electronic card
6 Power the product again to launch the automatic firmware updating procedure
Check the firmware has been correctly updated by verifying the release version indicated on the display
7
7.55.4.502.0 - Installation and Operation Manual
Description
when the station is switched back on
Gewiss
IT
EN
FR
ES
DE
RO
HU
NL
71