Safety; Safety Conditions; General Warnings - Gewiss JOINON Mode D'emploi

Gewiss

3. Safety

This section describes the safety warnings and the personal protective equipment.

3.1. Safety conditions

General warnings

The operations described in this manual may only be performed by duly qualified personnel.
When this manual refers to qualified personnel, this means personnel complying with all the standards, directive and
laws concerning safety, as applicable to the installation and operation of this device.
Only the company making the intervention is able to decide whether the person in question is capable of carrying out
a certain task, so the selection of qualified personnel is always the responsibility of the company, to ensure safety and
respect the relevant workplace safety regulations.
Such companies must provide appropriate training for its personnel in relation to the electrical devices, and make sure
that personnel are fully familiar with the contents of this manual.
It is mandatory to comply with the applicable safety laws related to electrical work. There is the risk of possible
electrical shocks.
Risk of electric shock.
Compliance with the safety instructions provided in this manual or by the indicated legislation does not imply exemption
from compliance with other specific standards relating to the installation, location, country or any other circumstances
that concern the electric device.
The opening of the casing does not imply the absence of voltage inside.
Interventions must only be carried out after disconnecting the system from the power supply by means of a device that
can guarantee electrical insulation.
It may only be opened by qualified personnel, following the instructions given in this manual.
It is mandatory to read and understand all parts of this manual before starting to handle, install or use the unit.
Gewiss declines all liability for any damage caused by inappropriate use of the charging stations. Any operation carried
out on these charging stations that involves a change in the original electrical settings must be authorised by Gewiss in
advance. All such proposals must be examined and approved by Gewiss.
Before carrying out any interventions, disconnect the system from the power supply by means of a device that can
guarantee electrical insulation.
The minimum safety measure for this operation is the observance of the following rules:
1. Disconnect the power supply.
2. Prevent the reactivation of the power supply.
3. Check there is no voltage.
4. Protect yourself against energised elements nearby, and place safety signals to mark off the work area if
necessary.
The product must be considered "live" until these operations have been completed, so no intervention can be
authorised.
Potential hazards for people
In order to protect your own safety, observe the following warnings.
46 7.55.4.502.0 - Installation and Operation Manual
Safety