Blower Speed; Night Light Dimmer Control; Split Fl Ow; Ember Bed - Napoleon Elevation X Serie Manuel Du Propriétaire

4.4

blower speed

The speed of the fan can be controlled by the remote
system. The fan speed can be adjusted through six (6)
speeds.
• Use the mode key to guide you to the fan control icon.
• Use the up/down arrow keys to turn on/off or adjust the fan
speed. A single "beep" will confi rm reception of the command.
note:
When the desired blower speed is selected, the blower will automatically come on 5 minutes after the main
burner has been turned on and remain on twelve minutes after it has been turned off.
4.5

night light dimmer control

note:
Controls the 2 accent lights at the rear of the appliance.
ADD TITLE: Night Light Dimmer Control
The auxiliary function controls the Night Light™ with dimmable control.
A. Use the mode key to guide you to the Night Light™ icon.
B. The intensity of the output can be adjusted through 6 levels.
Use the up/down arrow keys to adjust the output level. A single beep
will confi rm reception of the command.
4.6 split fl ow
The split fl ow function controls the ability to turn ON /
OFF a second burner.
1. Use the mode key to guide you to the split
fl ow function.
2. Pressing the up arrow key will activate the
second burner.
3. Pressing the down arrow key will deactivate
the second burner. A single "beep" will
confi rm the reception of the command.
note:
This is no way to modulate the flame heights separately.
4.7

ember bed

ADD TITLE: NIGHT LIGHT
The auxiliary function controls the AUX power outlet on the control module
ember bed.
which controls the Night Light™.
A. Use the mode key to guide you to the AUX icon.
B. Pressing the up arrow key will activate the Night Light™.
C. Pressing the down arrow key will turn the Night Light™ off. A single
"beep" will confi rm the reception of the command.
4.8

continuous pilot / intermittent pilot (CPI/IPI) selection

• When the transmitter is in the off position, use the mode key to guide
you to the CPI mode icon.
• Press the up/down to switch between IPI and CPI modes. A single
beep will confi rm reception of the command.
note:
If the appliance is equipped with a CPI/IPI* toggle switch, set the CPI/IPI
to CPI position to enable remote CPI operation. If the switch is set to IPI
then it will only work in IPI regardless of what is set on the remote control
handset.
* Some jurisdictions may prohibit the use of a standing pilot. In these jurisdictions, the CPI switch shall be
disconnected to comply with local code.
remote control operation
76
OFF
ember bed.
ember bed off. A single
76 76
°F
68 Hi
76
°F
OFF
76
°F
ON
76 76
°F
ON
OFF
76 76
°F
IPI CPI
W415-2001 / 09.27.19
EN
°F
76
°F
°F
°F
°F
9