Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
40
8.6
CONTINUOUS PILOT / INTERMITTENT PILOT (CPI / IPI) SELECTION
A.
Use the Mode Key to guide you to the CPI mode icon.
EN
Transmitter in the OFF position.
B.
Press the UP/DOWN to switch between IPI and CPI
modes. A single BEEP will confi rm reception of the
command.
NOTE: If the system is equipped with a CPI/IPI toggle
switch, set the CPI/IPI to CPI position to enable remote CPI
operation. If the switch is set to IPI then it will only work in
IPI regardless of what is set on the remote control handset.
8.7
KEY LOCK
This function will lock the keys to avoid unsupervised operation.
A.
Press the MODE and UP keys at the same time.
B.
To de-activate this function, press the MODE and UP keys at the same
time.
8.8
LOW BATTERY / MANUAL BYPASS
The life span of the remote batteries depends on various factors: quality of the
batteries, the number of ignitions, the number of changes to the room thermostat set
point, etc.
When the transmitter batteries are low, a Battery Icon will appear on the LCD
display before all battery power is lost. When the batteries are replaced this icon will
disappear.
Not applicable when plugged into 110V.
When the batteries are low, no "beep" will be emitted from the receiver when it receives an ON/OFF command.
This in an alert for the receiver that there's low battery. When the batteries are replaced the "beep" will be
emitted from the receiver when the ON/OFF key is pressed.
If the batteries in the battery holder or transmitter are low, the appliance can be turned on manually by sliding
the three position slider switch on the battery holder to the "ON" position. This will bypass the remote control
feature and the appliance main burner will come on. Likewise, if you want to manually turn the appliance off,
slide the switch to the 'OFF' position.
8.9
OPTIONAL BLOWER SPEED CONTROL
If the appliance is equipped with a hot air circulating fan,
the speed of the fan can be controlled by the remote
system. The fan speed can be adjusted through six speeds.
A. Use the Mode key to guide you to the fan control icon.
B. Use the Up/Down Arrow keys to turn ON/OFF or
adjust the fan speed. A single "beep" will confi rm
reception of the command.
NOTE: When the desired blower speed is selected, the blower will automatically come on 5 minutes
after the main burner has been turned on and remain on twelve minutes after it has been turned off.
W415-2180 / B / 08.29.18
76
°F
IPI
CPI
35.22
35.10A
35.23
76
°F
68
35.9B
76
°F
76
°F
76
°F
76
°F
Hi
Publicité
Chapitres
Table des Matières
Dépannage
