Connecting The Handpiece; Connecting The Foot Control; Connecting The Ac Power Cord - NSK Surgic Pro Manuel D'utilisation

4-2 Connecting the Handpiece

CAUTION
When using the Optic Surgic Pro micromotor (SGL70M), USE ONLY Optic contra-angle handpieces. Non Optic
handpieces may not precisely connect to the micromotor and it may malfunction when the micromotor is under
load.
1) Push the handpiece on to the motor taking care to keep it in
alignment.
2) Twist the handpiece until it locks into position with a clicking sound.

4-3 Connecting the Foot Control

Face the screw on the Foot Control Cord Plug downward
then insert the plug into the Foot Control Cord connector
socket on the Control Unit. Secure the plug by fastening
the Lock Nut. Refer Fig.3.

4-4 Connecting the AC Power Cord

Correctly align then insert the AC Power Cord into the
AC Power Cord Connector Socket at the back of the
Control Unit. (Fig.3)
4-5 Installing the Irrigation Tube
Ensure the Pump Cover Lever is in the 'OPEN' position, with the Irrigation tube 'Needle' towards the backside of the
Control Unit. Position the stoppers of the tube assembly in to the Tube Guide securely. (Fig.4)
<OPEN Position>
Pump Cover Lever
AC Power Cord
Pump Cover
Tube Guide
Fixed Position
8
Screw
Foot Control Cord Plug
Fixed Position
Water flow direction
Stopper
Fig.2
Fig.3
Fig.4