How To Connect The Parts - NSK ENDO-MATE AT Mode D'emploi

(D) PROGRAM No.
Displays the selected program No.
(E) GEAR RATIO
Displays the selected gear ratio.
(F) ROTATION MODE
Displays the selected rotation mode. "F" and "R" represent forward rotation and reverse rotation
respectively.
(G) AUTO REVERSE MODE
Displays the selected auto reverse mode.
AUTO REVERSE
*For details, refer to "8-3 AUTO REVERSE Function".
(H) ALARM SOUND VOLUME
Displays the selected alarm sound volume.
High Low
*For details, refer to "8-5 Selecting the Alarm Sound Volume".
5

How to Connect the Parts

5-1 Connection of the AC Adaptor
) Position the AC Adaptor plug so that
its bottom face, then insert it to the AC Adaptor inlet
on the side of the Control Unit. (Fig.)
2) Plug the AC Adaptor into a power outlet for medical
use.
• Do not pull out the AC Adaptor by holding and pulling its cords.
• Make sure that the device has stopped before connecting or disconnecting the AC Adaptor.
CAUTION
5-2 Mounting of the Contra Angle Head
() Mounting
) Make sure that the power is OFF.
2) Push the Contra Angle Head till its alignment
pins click into the alignment slots in the Motor
Handpiece. The Contra Angle Head can be
mounted at 6 patterns of angles. (Fig.2)
(2) Removing
) Make sure that the power is OFF.
2) Pull out the Head straight without twisting.
AUTO STOP
Limited OFF
mark is on
6
AUTO REVERSE OFF
Alignment pin
Contra Angle Head
Fig. 
Alignment slot
Motor Handpiece
Fig. 2