Positioning The Movement Sensor Pad - Angelcare AC417 Manuel De L'utilisateur

STEP 2 ‑ POSITIONING THE MOVEMENT SENSOR PAD
2.1 ‑ POWERING THE MOVEMENT SENSOR PAD
When using the Sensor Pad for the first time, you will need to insert the provided
CR3032 battery.
2.2 ‑ INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
If your cot does not have a solid, stable surface for the Sensor Pad, you will
need to place a support under it, to ensure correct operation of the system.
This hardboard support should be at least 6 mm thick and should have
minimum dimensions of 33 cm x 33 cm. This support board must be larger
than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except
memory‑foam mattresses, hollow frame mattresses and water beds. The
hardboard maintains a constant pressure on the Sensor Pad, enabling it to
detect the baby's movements even when the baby is at the edges of the cot.
Sensor Pad
WARNINGS
STRANGULATION HAZARD
• The Sensor Pad is not designed for use with adults, children or infants older than 24 months.
• Discontinue used of the Sensor Pad when baby is older than 24 months.
Deactivate the movement function and then remove Sensor Pad from cot and store
for future use.
• BEFORE FIRST TIME USE: To test that the unit is ready for use, refer to instruction
manual on how to test that the installation has been done correctly.
1) Remove the battery cover using
a coin. Turn in the direction of
the arrow.
2) Place the included battery
(CR3032) in the compartment.
Note: The + symbol should be
facing up.
3) Replace the battery cover
(the two dots will line up). The
Sensor Pad is now Activated.
1) Remove the mattress from the cot.
2
2) Place the Sensor Pad ‑ Angelcare
side up ‑ in the center of the mattress.
It should be centered on the hardboard
if your cot requires a hardboard
support.
3) Replace the mattress.
E
N
Hardboard
logo
®
65