Fault Finding Chart; Error Codes - BH FITNESS G-6488 Instructions De Montage Et Utilisation

FAULT FINDING CHART

PROBLEM
1. The monitor does
not switch on.
2. The
switches on but the motor
fails to start.
3. Walking motion is
jerky on the treadmill.
4. The machine stops
(the breaker trips).
5. Electrical
through the handrail.
6. The treadmill belt
skews off centre.

ERROR CODES

Monitor screen displays E1
Monitor screen displays E6-E7
Hesitate to get touch with us if you have any queries, by calling:
CHECKS
1) Make sure that the
machine is plugged in, the
ON/OFF switch in position 1
and that the safety key is
inserted.
monitor 2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on
the sliding belt.
3.c) Check the tension on
the drive belt.
4) Check that the band is
lubricated.
shocks 5) Check that the machine
is plugged into an earthed
mains socket.
6.a) Check that the machine
is level on the floor.
6.b) Check that the machine
does not wobble.
902 170 258
SOLUTIONS
1) Plug the machine into the
mains
switch to position 1 and
insert the safety key.
2) Switch the machine off
and
breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding
belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt
tension.
4)
button with the On /Off
switch at „0" and lubricate
the treadmill band.
5) Plug the machine into an
earthed mains socket.
- Possible motor overload.
- Lubricate the belt.
- Elevation fault.
22
supply. Set
press the
Reset the overload
the
circuit