Oase Varionaut 1 Mode D'emploi Et Consignes De Sécurité page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

-
English
-
Start-up
Caution! Do not damage the unit.
Protective measures: Never run the unit without water.
Pos: 21 /Lampen/Wasserspieltechnik/LED Twin-Star/Warnhinweis LED Twin-Star @ 8\mod_1211875832729_121.doc @ 47063 @
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures: Disconnect the power supply to the unit prior to reaching into the water and com-
mencing work.
Pos: 22 /Pumpen/Schlammsauger/Varionaut 1/INB DMX Steuergerät @ 10\mod_1235730631004_121.doc @ 60790 @
Start-up and operation are only possible with a DMX control unit. The DMX protocol is used for signal
transmission and pump control.
Pos: 23 /Pumpen/Schlammsauger/Varionaut 1/Sicherer Betrieb des Gerätes Varionaut 1 @ 8\mod_1222679996958_121.doc @ 53478 @
Safe operation of the unit
Only operate the Varionaut 1 if no persons are in the water.
Do not carry or pull the units by the connection cable.
Do not operate defective units. Never operate the unit if either the cable or the housing is defective! Pull the power plug
immediately. Repairs of connection cables may only be carried out by the manufacturer / supplier.
Place the Varionaut 1 such that any risk of injury for persons is excluded
Never open the housing or its component parts.
Prior to starting work on the Varionaut 1, disconnect the power supply (pull the power plug or deactivate the fuses) to
all units in the water.
Pos: 24 /Pumpen/Schlammsauger/Varionaut D-GB/Montage @ 7\mod_1208157516459_121.doc @ 46366 @
Installation
The unit can be set up either submerged (A) or dry (B). The following applies to both installation scenarios: Only
operate the unit with the shaft in the horizontal position. Never install the pump only suspended from the suction or
pressure socket. Ensure that the motor weight is additional supported in a suitable way. Remove the filter basket for
dry installation. For this purpose, turn the filter basket counter-clockwise.
Pos: 25 /Pumpen/Schlammsauger/Varionaut 1 USA/Anschluss der Stromversorgung Varionaut 1 USA @ 10\mod_1238153922100_121.doc @ 61521 @
DMX cable connection
How to connect the Varionaut 1 to the DMX control unit (C-D):
Remove the two screws from the DMX connection terminal and take off the cover cap.
Insert the plug of the DMX cable of the DMX control unit in the socket for the DMX input signal (DMX-IN) and secure by
means of the two screws.
How to connect several (max. 32) units to the DMX control unit (E):
Remove the two screws and take off the cover cap.
Insert the plug of the DMX cable in the socket for the DMX output signal (DMX-OUT) and secure by means of the two
screws. Insert the other plug of the DMX cable in the socket for the DMX input signal (DMX-IN) of the next unit.
Pos: 26 /Alle Produkte/Dummy_module/===== Seitenwechsel ===== @ 0\mod_1125648978015_0.doc @ 1631 @
6

Publicité

Table des Matières
loading

Table des Matières