ESAB Powercut 650 Manuel D'instructions page 106

SECtIoN 3
230 vac
BLACK
BLACK
GRAY
* Sized per National Code for 80°C rated copper conductors @ 30°C ambient. Not more than three conductors in
raceway or cable. Local codes should be followed if they specify sizes other than those listed above.
CUSTOMER FUSED LINE DISCON-
NECT SWITCH (See Table 3.1 and
WARNING in regards to chassis
ground in Section 3.4)
fACtorY SEt for 230 vac INPut
Do Not CHANgE ANY otHEr WIrES.
GRAY
INPUT BRIDGE (IBR)
rated Input
Volts Amp Phases
230 37/20 1/3
400 9 3
table 3.1. recommended Sizes for Input Conductors
and line fuses
Factory supplied primary
power cable with plug.
figure 3.1 Customer fused line Disconnect and receptacle
X3 HERE FOR 230 vac INPUT
X2 HERE FOR 230 vac INPUT
Input & gND
fuse Size
Conductor
Cu/AWg*
No. 6mm
No. 4mm
106
INStAllAtIoN
Amps
50/40
15