Start-Up; Transport And Assembly; Connection; Electrical Connection - Tractel Tralift TS Série Instructions D'emploi Et D'entretien

2 Start-up

DANGER !
Mechanical adjustments may only be performed by authorised specialists.
CAUTION !
Operating staff must carefully read the operating instructions of the electric chain hoists before its initial operation and carry out all
checks. Only when safe operation has been established may the device be put into operation. Unauthorised persons may not operate
the device or carry out work with it.

2.1 Transport and assembly

The safety directions for handling with loads should be followed (see chapter 0.3) when transporting and assembling the electric chain hoist.
Electric chain hoists must be assembled by qualified staff, always bearing in mind the accident prevention directions in chapter 0.2. Before
assembly the electric chain hoist must be stored in an enclosed room or covered area.
Should the electric chain hoist be destined for operation outdoors, then it is recommended that a protection cover is erected to shield it from the
effects of the weather.
Wherever possible, the electric chain hoist should be transported in its original packaging. The goods delivered should be checked for
completeness and the packaging disposed of in an environmentally sound manner. It is recommended that the electric chain hoist is assembled
and connected on-site by our qualified customer service personnel.

2.2 Connection

2.2.1 Electrical connection

DANGER !
Electrotechnical adjustments may only be performed by authorised specialists.
The mains connection cable, the mains connection fuse and the main switch for connecting the electric chain hoist to the mains power supply
must be installed beforehand by the customer.
A 4-wire cable with a PE protective conductor is needed to provide the power supply for three-phase models. A 3-wire cable with a protective
conductor is adequate for single-phase models. The length and cross-section must be appropriate for the power consumption of the electric chain
hoist.
Before connecting the electric chain hoist, check whether the operating voltage and frequency that are specified on the name plate
correspond to the available power supply
Remove cover on electrical side
Insert connecting cable with M25 x 1.5 screwed cable connection into hole at side and connect to terminals L1, L2, L3 and PE in accordance
with supplied circuit diagram (see figure 2-1)
Insert control cable with M20 x 1.5 screwed cable connection through hole in underside of housing and connect to terminals 1, 2, 3, 4 and 10
(see figure 2-2)
Attach strain relief to housing (see figure 2-3)
CAUTION !
The control switch must be attached to the strain relief cord and not to the cable.
Figure 2-1
PE
L1
L2
L3
Figure 2-2
3 21
5 4
Not Aus
1 2
1 speed
3
4
2 speed
3 4
1 speed
4 3
2 speed
3 4
Figure 2-3
11