Yamaha F200 Manuel De L'utilisateur page 70

Operation
4. Turn the main switch to "
sure that the digital electronic control-
active indicator lights. The engine can
not be started when the digital electronic
control-alert indicator lights.
ON
OFF
5. Turn the main switch to "
and hold it for a maximum of 5 seconds.
NOTICE: Never turn the main switch
to " " (start) while the engine is
running. Do not keep the starter motor
turning for more than 5 seconds. If the
starter motor is turned continuously
for more than 5 seconds, the battery
will be quickly discharged, thus mak-
ing it impossible to start the engine.
The starter can also be damaged. If
the engine will not start after 5 sec-
onds of cranking, return the main
switch to " " (on), wait 10 seconds,
then crank the engine again.
ON
63
" (on) to make
ZMU07217
" (start),
[ECM00193]
START
ZMU07169
When starting the engine using the
Start/Stop button, press the button to
start the engine. The indicator for the
starting engine will come on.
When starting the engine using the
Start/Stop button on the All Start/Stop
switch panel, press the button to start
the all engines.
TIP:
 When the main switch is turned to "
(start) with the clip removed from the en-
gine shut-off switch, the buzzer will sound.
 For twin type, if the clip is removed from the
engine shut-off switch, the buzzer will
sound when the Start/Stop button is
pressed.
 For twin type, when either engine has start-
ed, the engine that has started can be
stopped by pressing the Start/Stop button
on the All Start/Stop switch panel.
ZMU07148
ZMU07150
"