General Description (Fig. 1) - Philips PSD1111/10 Mode D'emploi

ENGLISH
8
- Always use the Philips BlueControl in the strap with the arm or leg
sling provided, as these strap and slings have been specially designed
for this device.
- Philips BlueControl is intended for daily use. The exact usage time is stated
in chapter 'Using your Philips BlueControl', section 'Treatment schedule'.
Compliance
The Philips BlueControl complies with the standard of basic safety for
medical devices (IEC60601-1) and with the relevant collateral and
particular standards for non-laser light source medical equipment for home
use: EN 60601-1[1], EN 60601-1-11 [3], EN 60601-2-57 [2], and EN
60601-1-2 [4]. Regarding electromagnetic compatibility (EMC) and
electromagnetic fields (EMF), the device should be kept away from radio
frequency (RF) equipment to avoid interference.

General description (Fig. 1)

1 Philips BlueControl
2 LED indicator
3 Micro USB socket
4 On/off button
5 Sensor
6 Strap with Philips BlueControl holder
7 Philips BlueControl securing sling
8 Arm sling
9 Leg sling
Charging
Fully charge the Philips BlueControl before you use it for the first time.
When fully charged, the Philips BlueControl has enough power for at least
two treatments. It is recommended to charge the Philips BlueControl after
each use. You can charge the Philips BlueControl with the adapter and
USB cable supplied. The adapter and USB cable have an expected life time
of at least 3 years in normal intended operation.When Philips BlueControl
is connected to the charger and in charging mode, the charger PR3089 is
to be considered as a part of the medical equipment.
Note: Treatment is not possible when the Philips BlueControl is charging.
Charging with the adapter
It takes approximately 2 hours to fully charge the Philips BlueControl.
1 Put the mains plug in the adapter and lock it into place.