Treatment Schedule - Philips PSD1111/10 Mode D'emploi

2 Insert the standard USB plug into the socket on the adapter.
3 Insert the adapter into the wall socket (100V-240V).
4 Insert the micro USB plug into the socket on the Philips
BlueControl.
When the Philips BlueControl is connected to the mains, it beeps
,
once and the LED indicator starts flashing green slowly to indicate
that charging has started.
5 When the Philips BlueControl is fully charged, the LED indicator
lights up solid green.
6 Remove the adapter from the wall socket and pull the USB plug out
of the micro USB socket on the Philips BlueControl.
Using your Philips BlueControl

Treatment schedule

Always stick to the recommended treatment schedule. Do not treat
more than once a day.
The Philips BlueControl has been designed for daily use on psoriasis
vulgaris plaques. We recommend treating single, non-overlapping psoriasis
vulgaris plaques only once a day. A single treatment takes approximately
30 minutes, but can be extended to 40 minutes depending on your skin
sensitivity and possible treatment pauses during treatment. For example,
if the infrared sensor senses a too high skin temperature, the treatment
is briefly paused for safety reasons. Treatment resumes automatically when
the skin has cooled down. Following this treatment advice ensures that
you do not exceed the daily light dose of 90 J/cm². Blue Light treatment
can be combined with Vitamin D creams. Apply the cream after the
treatment. For other combination treatments with Blue Light, please
consult your doctor. We do not recommend using topical medication,
creams or lotions immediately before and during treatment with the Philips
BlueControl. In case of unpleasant effects such as excessive, non-resolving
skin redness, worsening of plaques or pain, stop treatment immediately
and consult your doctor if necessary. A temporary increased redness of
the treated area after therapy is normal but should diminish.
ENGLISH
9