Putting The Device Into Operation; Technical Data; Article Number Of The Charger; Attaching The Decorative Front Panel - Porsche Wall Charger Connect Mode D'emploi Et Instructions D'installation

Closing the cover

Before switching on the Wall Charger Connect, the
cover must be secured using the enclosed screws.
b Use Torx TX 25 screws.
e Tighten the 13 screws to secure the cover with
a tightening torque of 3.3 ftlb. (4.5 Nm).
Fig. 16: Screw points of the cover

Attaching the decorative front panel

The decorative front panel is secured via four screws.
The screwholes are in the recess for winding the
cable (not visible from the front).
e Position the decorative front panel on the device
and fix with the four screws (tightening torque
3.0 ftlb. (4 Nm)).
To do this, use a Torx TX 25 screwdriver
with a short shaft.
Fig. 17: Screw attachment points in the recess for winding
the cable (rear view of the Wall Charger Connect)

Putting the Device into Operation

e Switch on the charger by pressing the Power
button.
In the display, the control panel for the further
setup of the device appears.
f Please see chapter "Operating Instructions" on
page 7.
Installation Instructions

Technical Data

Electrical data

9J1.068.209
Power 19.2 kW
Rated current 80 A
Rated voltage 120/208-
240 V AC, 120 V to
ground
Phases 1/2
Power supply frequency 50 Hz/60 Hz
Overvoltage category II
(IEC 60664)
Integrated residual current Type A (AC: 20 mA)
device + DC: 56 mA
Protection class I
Degree of protection Enclosure 3R (IP55)
Transmission frequency 2.4 GHz, 5 GHz
bands
Transmission power 20 dBm

Mechanical data

Weight 29 lbs. (13 kg)
Vehicle cable length 14.8 ft (4.5 m)

Ambient and storage conditions

Ambient temperature –22 °F to +122 °F
(–30 °C to +50 °C)
Humidity 5%–95% non-
condensing
Elevation max. 13,123 ft.
(4,000 m) above
sea level
US
FC
ESM
21