Log Placement - Napoleon Ascent 35 Manuel D'installation Et D'opération

10.7

log placement

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
PHAZER logs and glowing embers, exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect that
TM
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A. Place the rear log (W135-0543) firmly onto the
two studs located at the rear of the support
tray. Ensure the log sits flat and does not
cover the pilot opening. Place two pins in
holes located on the top of the rear log.
Place the right log (W135-0545) onto the two
C.
studs located on the right side of the log
support.
PINS
A
A
C
B
PIN
B
B. Place the left log (W135-0544) onto the two
studs located on the left side of the log support.
D
B
D. Place the left crossover log (W135-0546) onto
the pin located in the left side of the rear log,
allow it to rest in the notch of the left log.
finishing
48.1
A
A
C
W415-1399 / D / 10.15.18
EN
47