Glowing Embers; Logo Placement - Napoleon Ascent 35 Manuel D'installation Et D'opération

finishing
EN
D
E. Place the right crossover log (W135-0589)
onto the pin located in the right side of the rear
log, allow it to rest in the notch of the right log.
10.8

glowing embers

WARNING
!
• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
Tear the embers into pieces and loosely layer above the burner ports covering the burner area. Care should be
taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow.
The ember material will only glow when exposed to direct fl ame; however, care should be taken to not
block off the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER™
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER™ logs available from
your local authorized dealer / distributor.
10.9

logo placement

Remove the backing of the logo supplied and place, as illustrated.
48
W415-1399 / D / 10.15.18
A
E
C
B
F. Reinstall the door and safety screen (see
"safety barrier / door removal and installation"
section).
1/2"(12.7mm)
45.5
22.1
INSERT
LOGO
IMAGE
1/2"(12.7mm)
HERE