Adaptor Kit (4758Ak) - Napoleon Ascent 35 Manuel D'installation Et D'opération

2.7.2 adaptor kit (4758AK)

note:
The adaptor must be installed directly onto the appliance collars before vertical rise.
TAKE VENT
MEASUREMENTS
FROM THE TOP OF
THE ADAPTOR
When using the adaptor kit (4758AK), vent measurements must be taken from the top of the
note:
Clearance to combustible measurements will not change when using the adaptor kit 4758AK. Refer to
"minimum enclosure clearances" section for information.
1
USE MILL PAC TO SEAL ADAPTER TO THE APPLIANCE COLLARS.
3
USE MILL PAC TO SEAL THE INNER PIPE TO THE ADAPTER.
5
USE MILL PAC TO SEAL THE OUTER PIPE TO THE ADAPTER.
ADAPTOR KIT
adaptor to the 4/7" venting.
2
4
6
venting requirements
14.4
W415-1399 / D / 10.15.18
EN
X3
X3
X3
17