Installation
1. Install the mounting brackets and burner tray cover
to the fi rebox as per instructions supplied with the
922 engine.
2. Install the black canopy shield to cover the
openings in the cast iron canopy.
a) Lay inner arch face down on the fl oor. Insert one
corner of the shield into the corner behind the
arch's cast frame as shown.
b) Bend the canopy shield to a slight radius while
inserting the other corner behind the arch's cast
frame as shown (it may be necessary to loosen
or remove one or two of the canopy bolts).
c) With both corners behind the arch's cast frame,
snap the shield forward to follow the curve of the
cast iron canopy. The top of the shield should
fi t under the projecting ledge in the frame as
shown.
3. Fasten the top fi ller piece to the back of the outer
cast arch.
4. Mount outer cast arch to brackets on fi rebox as
shown below.
5. Hang the inner arch on the outer arch and install
wire guard as shown below.
Rest wire guard
on fendre and clip
top under canopy
Hearth fender
rests on hearth
Fasten outer
arch to brackets
using 2 screws
per side
Inner arch hangs
within outer arch
on 2 hooks
9