Publicité
Les langues disponibles
Les langues disponibles
Installation
1. Fit Top Baffl e under the top panel of the appliance
case. Secure with 2 thread forming screws. Fit the
top air defl ector to the top baffl e as shown using the
2 screws provided.
2. Mount Stand-off Spacers. The stand-off spacers
are supplied fl at and are left and right handed.
a) Remove the 2 screws near each of the rear top
corners of the appliance and the 2 screws near
the rear top of each side.
b) Bend the spacers as shown.
c) Screw the spacers to the rear of the appliance
using the screws just removed.
d) Bend the side wings of the spacers to align the 2
holes in each spacer with those in the appliance
sides.
e) Secure the spacers using the screws just
removed.
! Warning: Failure to install the stand-off spacers
may result in a fi re hazard.
3. Locate Side Mounting Brackets as shown and line
up the mounting holes in the side of the heater body.
Secure the side brackets to the heater using the
screws provided —2 per side.
(Note that the spacer brackets are to remain on
for ZC application of 26". For insert application,
spacers can be removed for 24" openings.)
4. Locate Top Insulation Pad. For top vent outlet
appliances, cut out a circle at the center of the
insulation layers for the vent collar. Place both
the insulation layers on top of the appliance case
inboard of the stand-off spacers.
! Warning: Failure to install both the insulation
layers may cause a fi re hazard.
5. Secure the Outer Cast Plate to the appliance with
self-tapping screws provided as shown. Tighten the
screws enough to ensure a tight fi t between casting
and sheet metal parts.
(It may be necessary to re-drill 1/8" pilot holes for
the self-tapping screws due to misalignment caused
by shifting tolerances with the cast iron arch.)
Note: The weight of the cast plate must not be
carried by the connection to the heater. It must sit
on a hearth or be securely screwed to the wall.
5
Publicité
