Publicité
Les langues disponibles
Les langues disponibles
Dimensions & Clearances—
549 Windsor Arch front (without back plate)
31"
Note: The 549 Windsor Arch front is intended for
insert applications only and does not include the
stand-offs and insulation pads required for zero
clearance applications. Most recessed 530 insert
applications will also require a 556CLA Co-linear
Adapter.
(Note that the spacers fi tted to the side brackets
can be removed for a 24" wide insert opening—see
no. 3. in the Installation section on page 5.)
Framing
• The framing dimensions for installation
of the 530 heater with the models 539
or 550 Arch Fronts are shown in the
Framing Diagram.
• A non-combustible hearth is not
necessary in front of the 530 heater.
• The 530 is approved for installation
directly on any combustible material
other than soft fl ooring material such
as carpet or vinyl.
• Any framing construction must be clear
of the standoffs—see Dimensions &
Clearances and Framing Diagram.
• A hearth, fl ush with the bottom of the
heater, will be required to support the
removable hearth fender.
4
'X'
Mantel
Top or Rear
Outlet
6"
'Y'
Min. 36" to
combustible
materials
4-1/8"
11-1/2"
Minimum depth
some installations
may require more
Framing Diagram
24"
20"
Min. 4"
Max. 8" deep mantel leg
at edge of arch
556CLA
Adapter
Required
Note:
556CLA Adapter
(top or rear outlet)
Required
2-1/2"
Side Mounting Brackets
37"
Publicité
