Valor 539 Série Manuel D'installation Et D'utilisation page 6

6. Hang the Inner Cast Arch. Insert the mounting
hooks into the notches in the outer cast plate
as shown. The fi t or gap between the inner cast
arch and the outer cast plate may be tightened by
bending the mounting hooks slightly inwards.
Do not bend the hooks too far or the inner arch
will be diffi cult to remove!
If this happens, a screwdriver inserted through the
gap between the back of the inner arch and the
heater should be able to pry the hook away from
the backing plate. Do not hit the hooks with a
hammer as this may break the welds holding
them.
Slide the hearth fender up to the front of the casting.
Note: It is important that the hearth in front of
heater be fl ush with the bottom of the heater;
otherwise the hearth fender will not rest at the
proper height.
7. With the 550 Arch front, the hearth fender hooks
into place on the inner cast arch.
6
8. Install the barrier screen by snapping the barrier
screen's top part to the inner arch. Then slide the
screen up slightly under the hood, snap the bottom of
the barrier to the inner arch and slide the screen back
down so it rests on the cast fender's upper edge.