Nordson ProBlue P4 Manuel page 257

E 2011 Nordson Corporation
5. Select the COM port you are using to connect to the melter, and then
click Ok.
The PC and melter establish communications and a picture of the melter
you selected appears in the device status area. The right side of the
status area indicates "CONNECTED".
6. Click Save Settings.
The Save As dialog box appears.
NOTE: The default location for saving settings files is Windows My
Documents folder. To avoid losing saved settings files, Nordson
Corporation recommends that you do not change the default save
location.
7. Type a file name to identify the group of settings you are saving, and then
click Save.
The save settings progress bar indicates the status of the save. When the
save is complete, the melter automatically returns to the scan mode.
NOTE: If you are using the NCM to save multiple variations of melter
settings, use a file naming convention that will allow you to easily
associate each settings file (.ncm extension) with its related process or
end‐use.
8. Click Ok to close the NCM.
To restore melter settings
1. Follow steps 1 through 5 of To save melter settings.
2. Click Restore Settings.
The Open dialog box appears.
3. Select the settings file (.ncm extension) that you want to restore, and then
click Open.
The Restore Settings progress bar indicates the status of the restore.
When the restore is complete, the melter automatically returns to the
scan mode.
Melter Communications
Part 1024496_05
C‐7