A&D UA-702 Manuel D'instructions page 4

Symbols
Turns the device on and off.
Guide to install battery
Direct current
Serial number
SN
Date of manufacture
Type BF: Device, cuff and tubing
are designed to provide special
protection
shocks.
Appears when measurement is in
progress and flashes when the
pulse is detected.
Flashes
remaining in the cuff at power up.
Flashes at the completion of the
measurement
complete.
The pulse is detected immediately
after the measurement has begun.
Appears when the battery voltage
is too low for the device to work
properly.
Appears when the blood pressure
can not be measured accurately.
Appears when the pulse is not
detected correctly.
Flashing
The exhaust rate is greater than 8
exhaust
mmHg/s.
velosity
The medical device label by the
EC directive
Registered with the Australian
Communication Authority by the
Trademarks office.
Function / Meaning
against electrical
when there
until exhaust
ENGLISH 3
___________
___________
___________
___________
___________
___________
Measurement is in progress -
- remain still.
is air
Press the
button to exhaust the air.
is
Increase pressurization by 30
to 40 mmHg and measure
again.
Replace all batteries with
new ones.
First exhaust the air from the
cuff, then re-apply the cuff
properly and measure again.
First exhaust the air from the
cuff, then re-apply the cuff
properly and measure again.
Adjust the exhaust rate to 2
to 5 mmHg/s.
___________
___________
Treatment
exhaust valve