Important - Contimac AL210E Manuel D'instruction Pour L'installateur

3. Connect the plug into the socket, making sure
that it is correctly inserted and check that the
plug is 15 Amp minimum.
4. Start the compressor by pressing the switch
ON/OFF. Couple the equipment by means of the
quick valve or ball valve. When the tank pressu-
re displayed on the main pressure gauge has
reached 4 bar minimum, work can be started.
Our compressor can be used with any kind of
tool, by setting the outlet pressure by hand.
Rotating the knob allows to increase or reduce
the outlet air pressure. This pressure can be
read on the pressure gauge or on the special
graduated ring nut, starting using the tool con-
nected to the matching outlet.

IMPORTANT

!
After use, switch off the compressor motor
by pressing the pressure swithc knob and
disconnect the plug. Empty the tank comple-
tely, loosening the blowing off valve plug, in
order to release the tank from possible con-
densation that may have built-up inside
during the operation.
DO NOT:
Do not paint in closed environments or near
open flames.
Do not touch the cylinder head, the cooling fins
and the delivery tube, as they can reach very
high temperature during operation, and remain
hot for a while after the compressor stop.
Do not place inflammable objects or nylon and
cloth objects near and/or on the compressor.
Do not transport the compressor with the tank
under pressure.
Do not use the compressor if the power supply
cable is damaged or if the connection is preca-
rious.
Do not direct the air blow toward persons or
animals.
Do not allow anyone to operate the compressor
if the proper instructions are not previously
given.
Do not hit the rotors with contending or metal
objects, as this may lead to the sudden break of
the rotors during operation.
Do not operate the compressor without an air
filter.
Do not temper with the air tank and/or the
safety valve!
Fig. A
6