Connection To Ice Machine - Manitowoc iAuCS Manuel D'installation, D'utilisation Et D'entretien

Section 2
4. Remove the backing from the adhesive bumpers. Attach
bumpers to the mounting bracket directly above the
iAuCS® control box. This eliminates upward movement
and stops the tabs from disengaging the key slots.
MNunotng
Braikeo
MNunotng oN Iie Maihtne
MNunotng oN Wall
The iAuCS® is mounted to the wall using the two key slots in
the back wall of the accessory. Screw fasteners (not supplied)
must hold the entire weight of the iAuCS® (approximately 10
lbs. [4.5 kg]).
Key SlNo DtmenstNns
Part Number 000009036 Rev03 9/18
Gaskeo
Bumper
6.56"
(16.6 im)
CO

ECTIO
TO ICE MACHI
E
Eleiortial CNnneiotNns
1. Check electrical code for your area.
• When local code allows, the included wire and strain
relief can be used for line voltage wiring. Remove
knockout from ice machine and install strain relief
and wire.
• When conduit is required, remove strain relief and
ice machine electrical knockout. Install conduit as
required by your electrical code.
n
Disconnect the electrical power supply to the ice machine
at the electrical disconnect before proceeding.
• Connections on ice machines vary. Refer to the
diagram for the ice machine you are working on.
2. Remove the front, top, and right side panels from the ice
machine.
3. Route line voltage wires through control box line voltage
Heyco fitting. Connect line voltage wires to incoming
power supply of contactor and ground screw.
NOTE: On QuietQube Ice Machines the power connection
is made at the incoming power supply (L1 and L2). Cut-off
yellow terminal (L2) and purple terminal (L1) on iAuCS®
harness. Strip insulation back 1/2" and connect.
CNnneio oN tniNmtng
pNwer supply Nf
iNnoaioNr Nbservtng
prNper pNlartoy fNr
115V
Installation
Warntng
LNw VNloage
HeyiN
Ftootngs
CNnneio
grNund wtre
oN grNund
sirew
Ltne VNloage
HeyiN
Ftootngs
11