Indigo® Nxt Model Procedures; Indigo® Nxt Automatic Operation; Indigo® Nxt Setting Frequency Of Cleaning; Indigo® Nxt Hose Priming - Manitowoc iAuCS Manuel D'installation, D'utilisation Et D'entretien

Operation
Indigo® NXT Model Procedures
INDIGO® NXT AUTOMATIC OPERATION
The following occurs when the ice machine is in ice making
mode:
• A cleaning sequence starts when the time interval equals
the Frequency of Cleaning setting of the iAuCS®.
• When the clean sequence is complete
(approximately 35 minutes depending on model), ice
making resumes until the next cleaning setpoint.
INDIGO® NXT SETTING FREQUENCY OF CLEANING
1. Navigate to iAuCs® on the touchscreen:
Menu/Settings/iAuCs®.
2. Select On then use the arrow key to select the frequency
of cleaning from once a month, up to once every six
months.
3. Press the home icon to return to the home screen.
16
INDIGO® NXT HOSE PRIMING
Priming the pump is required on the initial installation or the
dispense hose does not contain solution.
n
Do not blow into or suck on the hose in an attempt to
prime it.


Important
iAuCS® does not operate when the CLEAN button is used
to start a clean cycle. To prime the hose, activation is
required through the Service Menu/iAuCS® icon.
Perform the following procedure:
1. Remove all ice from the evaporator(s) before priming.
2. Place a bottle of cleaner or sanitizer in the
iAuCs®cabinet. Insert the pump inlet hose into the bottle
and verify the pump outlet hose is correctly attached to
the ice machine. Refer to "Installing/Replacing Cleaner
or Sanitizer Bottles" on page 15.
3. Navigate to iAuCs® on the touchscreen:
Menu/Service/iAuCs®.
4. Select On - A cleaning cycle will start by purging the
water in the water trough. When the water trough refills
and water contacts the water level probe, the iAuCs®
pump will energize and prime the pump (touchscreen
displays step 4).
NOTE: After the iAuCs® pump dispenses, the washing, rinsing
and flushing cycles must complete before an ice making cycle
can start.
5. The ice machine will turn off at the end of the cycle.
To automatically start ice making when the cycle is
complete, press the power button Off, then On during
either the wash or rinse cycles. The clean cycle will
resume from the beginning of either the washing
or rinsing/flushing cycle, depending on the point of
interruption.
Part Number 000009036 Rev03 9/18
Section 3
Warning