Indigo® Model Procedures; Indigo® Model Automatic Operation; Setting Frequency Of Cleaning Indigo® Models; Indigo® Model Hose Priming - Manitowoc iAuCS Manuel D'installation, D'utilisation Et D'entretien

Operation
Indigo® Model Procedures
INDIGO® MODEL AUTOMATIC OPERATION
The following occurs when the ice machine is in ice making
mode:
• A cleaning sequence starts when the time interval equals
the Frequency of Cleaning setting of the iAuCS®.
• When the clean sequence is complete
(approximately 25 minutes depending on model), ice
making resumes until the next cleaning setpoint.
SETTING FREQUENCY OF CLEANING INDIGO® MODELS
The iAuCS® unit is factory-set to initiate and complete a clean
sequence approximately once every two weeks.
iAuCS®
For less frequent cleaning, use the controller to select an
interval.
1. Press Menu.
2. Scroll to Setup and press right arrow.
3. Scroll to iAuCS Runtime and press right arrow.
Display reads:
iAuCS on
iAuCS off
Set interval
Exit
4. Select iAuCS on and press check mark.
5. Select Set interval. Display reads:
.5 mo
1 mo
2 mo
3 mo
4 mo
5 mo
6 mo
Exit
6. Select desired time period and press check mark
(15 days, 1 month, 2 months, etc.).
7. Press left arrow repeatedly to exit to Main screen.
18
INDIGO® MODEL HOSE PRIMING
The dispenser pump requires priming after initial installation,
or if the hose between the iAuCS® reservoir and pump has
been pumped dry or the tubing between the iAuCS® pump
and the ice machine has been pumped dry.
n
Do not blow into or suck on the hose in an attempt to
prime it.
Perform the following procedure:
1. Press the CLEAN button.
2. The water pump and dump valve will turn on. The dump
valve will shut off after approximately 45 seconds.
3. The control waits until water contacts the water level
probe then energizes the iAuCS® pump (22" or 30" ice
machines - 30 seconds, 48" ice machines - 60 seconds).
4. Allow the ice machine to complete the cleaning or
sanitizing cycle.

Important
The priming procedure starts the automatic cleaning
mode. After starting an ice making cycle, the ice machine
will run through 6 rinse and dump cycles before making
ice.
Part Number 000009036 Rev03 9/18
Section 3
Warning