Fitting The Operator; Preparation For Installation - Aprimatic AT 80/E Notice D'installation Mécanique, D'utilisation Et D'entretien

SLIDING GATES
4.

FITTING THE OPERATOR

Realise the foundation for the plate to be cemented and use
the fi xed or pivoting support kit to install the operator.
!
Warning
Other assembly methods where the motor base is not
horizontal are forbidden by the manufacturer.
During the inspection in-situ the installer must ensure
there is space enough all around the gate panel suffi cient
for the overall dimensions considering the installation
type: fi xed or pivoted Fig.7 A-B.
4.1

Preparation for installation

The support base for the operator must be result a few
centimetres above the surrounding ground level.
In very snowy zones or areas subject to flooding we
recommend positioning the plate 10-12 cm above the
ground surface.
!
Warning
It is essential that the foundation works be carried out
perfectly, following the Fig.10-11 instructions, in order
to obtain the correc position of the operator and the
electrical cable with respect to the wing gate.
• Excavate a trench (dimensions given in
with good-quality cement.
• Position the plate with the bended clips into the cement
trench (Fig.9).
IMPORTANT! Check the horizontal position of the plate with
a level - Meet the Fig.10 quotas.
OPENING
closing
end limit
plate
X
(50 mm)
opening safety
mechanical stop
X = safety distance in compliance with the current standards
ADJUST THE END LIMIT PLATES IN SUCH A WAY TO ANTICIPATE THE
MECHANICAL STOP POSITION OF THE GATE OF THE DISTANCE X
Fig.8) and fi ll it
Fig.11
CLOSING
opening
end limit
plate
rack
gate
X
(50 mm)
DO NOT POSITION THE OPERATOR
.
IN THE TRANSIT AREA
.
AT 80/E
Fig.7A
2 0
m m
!
The plate must be perfectly level !
Remove any cement splashes.
45°
Ø 35 mm cable
for passage tube
220 mm
!
Electrical cable
tube has to be placed
outside the foundation
plate
- 18 -
A mm
180 max
A
70 min
OPENING CLOSING
90°
gate
foundation plate
Fig.7B
Fig.8
Fig.9
Fig.10