Product Technical Features; Destined Use And Working Range; Residual Risks; Technical Data - Aprimatic AT 80/E Notice D'installation Mécanique, D'utilisation Et D'entretien

1.

PRODUCT TECHNICAL FEATURES

Geared-motor for use intensive on sliding gates. The
mechanical parts and the electric motor are in an oil, making
it possible to use the operator under the most severe
conditions.
• Control unit on machine board.
• Safety against crushing : electro-mechanical limit switch
and adjustable oil bath clutch (part of geared-motor).
• Release lever with a customized key.
• Installation requires the foundation plate and a support Kit
(for fi xed or pivoting installation - see the Catalogue).
1.1

Destined use and Working range

AT 80/E operator is designed to automate the movement of
max. 1200 Kg sliding gates for residential-use, or of max.
800 kg for condominium-use (pinion Z20 is necessary).
Any other use whatsoever is not authorised by
Aprimatic.
Caution
It is forbidden to use the product improperly or for different
aims than those intended.
It is forbidden to tamper with or modify the product in any
way whatsoever.
The product must only be installed with APRIMATIC
accessories.
1.2

Residual risks

!
Warning
Take care when the gate is opening as there is a risk of injury
of hands or other parts of the body in the operating area of
the operator gear.
!
Warning
The operator cannot be considered a supporting part or a
safety device of the gate; the gate must be provided with
adequate support systems and safety device.
1.3

Technical data

To see Tab.1.
!
Warning
The maximum weight of the gate is only a partial
parameter for determining the limits to use, as gate
sliding MUST also be taken into account.
1.4

Overall dimensions

To see Fig.1.
1.5

Supply inspection

Ensure that the package contains all the components listed
and check for damage. Make sure the model acronym
printed on the packaging corresponds to the one affi xed on
the gear motor (Fig.2).
See the list of the
COMPONENTS SUPPLIED WITH THE OPERATOR
those to be
PURCHASED SEPARATELY
AT 80/E
and
in Tab.2 and Fig.3.
- 15 -
SLIDING GATES
T .1 -
AB TECHNICAL DATA
Single-phase power supply
Max absorbed power
Max accessories current supply
MAX WEIGHT OF GATE
RATED THRUST FORCE
(1N = ~0,102Kg)
RATED WING SPEED
LUBRICANT quantity
LUBRICANT type
Degree of protection
Operating temperature
Number of daily cycles
188
IB80*
190
Ø 40
Aprimatic
S.p.A. MADE IN ITALY
TYPE : ............................
AprimOil xx C.I. F
230V~ 50Hz xx W xx A
xx g/min mm/sec
xxx Nm / IPxx
!
XXX X00000000xxxxxx
230V 50Hz ± 6%
330W
1 A
1200 Kg (pinion Z16)
800 Kg (pinion Z20)
1400 N (Z16)
1120 N (Z20)
9,5 m/min (Z16)
12 m/min (Z20)
1,25 l
AprimOil DN22
IP 44
-20 / +70 °C
Max. 50
Fig.1
290
IF80*
35
5
Fig.2