Stuart CB160 Manuel D'utilisation page 5

Accessory
A rod is available to support apparatus used with
the instrument. The instrument is equipped with
a fitting on the rear to accept the support rod -
catalogue number SR1, (see figure 2). To fit the
rod to your instrument, first isolate from the
mains supply and allow to cool. Then simply
screw the threaded end of the support rod into
the fitting on the rear of the instrument.
Servicing and Repair
This product range does not require any routine
servicing.
Note: There are no internal user replaceable
parts.
In the event of product failure it is recommended
that any repair is only undertaken by suitably
qualified personnel. For advice or to receive a
service manual please contact the Technical
Service Department of Barloworld Scientific Ltd.
Only spare parts supplied by Barloworld Scientific
or its agent should be used. Fitting of non-
approved parts may affect the performance of
the safety features of the instrument.
Note: The magnetic stirrer drive utilises
strong magnets.
If in doubt, please contact the Technical Service
Department of Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail equipment@barloworldscientific.com
www.barloworldscientific.com
Spares
The following spare parts are available from your
laboratory supplier. For a comprehensive parts list
please contact the Technical Service Department
of Barloworld Scientific Ltd quoting model and
serial number.
Description
Control knob
Rubber feet, set of 4
Retort rod,
Warranty
Barloworld Scientific Ltd warrants this instrument
to be free from defects in material and
workmanship, when used under normal
laboratory conditions, for a period of two (2)
years. In the event of a justified claim Barloworld
Scientific will replace any defective component
free of charge.
This warranty does NOT apply if,
1. A ceramic top has broken due to mechanical
impact, scratching, chipping or chemical
etching.
2. Any repair has been made or attempted other
than by Barloworld Scientific or its agent.
Cat. No.
SB160/CK
SB160/RF
SR1
3