Remote Control And Keyless Entry; Homelink - Chamberlain B353 Guide De L'utilisateur

Operation

Remote Control and Keyless Entry

Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain
remote controls are NOT compatible.
Program Using the Multi-Function or Motion Detecting Control Panel
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control: Press the button on the remote control that you wish to
operate your garage door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your
choice on the keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has
been programmed. Repeat the steps for programming additional remote controls or
keyless entry devices. If programming is unsuccessful, repeat the steps using the learn
button on the garage door opener.
1 2
The command LED The command LED will
will flash once flash once again.
3
OR
?
Program Using the Smart Control Panel
1. Press the navigation button below "MENU" to view the Features menu.
2. Use the navigation buttons to scroll to "PROGRAM".
3. Select "REMOTE" or "KEYPAD" to program from the program menu.
4. Remote Control: Press the button on the remote control that you wish to
operate your garage door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your
choice on the keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has
been programmed. Repeat the steps for programming additional remote controls or
keyless entry devices. If programming is unsuccessful, repeat the steps using the learn
button on the garage door opener.
1
3
4
? ? ?
PIN
®
2
Press to continue
Press to continue
MYQ WI-FI OPENER
REMOTE
MYQ ACCESSORY
KEYPAD
OR
? ? ? ?
PIN
19
Program Using the Garage Door Opener Learn Button
1. Locate the Learn Button.
2. Press and immediately release the Learn button. The Learn LED will glow
steady for 30 seconds. Within 30 seconds...
3. Remote Control: Press and hold the button on the remote control that you
wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your
choice on the keyless entry keypad. Then press and hold the ENTER button.
Release the button when the garage door opener lights blink or two clicks are heard.
When replacing the light lens cover, ensure the antenna wires are hanging straight down.
1-2
3
PIN
®

HomeLink

If your vehicle is equipped with HomeLink, a Compatibility Bridge
necessary for certain vehicles. Visit bridge.chamberlain.com to find out if a Bridge is
needed.
LEARN
Button
LEARN LED
TM
(not included) may be