Erase The Memory; To Open The Door Manually - Chamberlain B353 Guide De L'utilisateur

Operation

Erase the Memory

Erase All Remote Controls and Keyless Entries
1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6 seconds). All remote
control and keyless entry codes are now erased. Reprogram any accessory you wish to use.
Erase All Remote Controls, Keyless Entries, and myQ
1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the learn LED goes out. All codes are now erased. Reprogram any
accessory you wish to use.
Erase the Connection from Garage Door Opener to Home Wi-Fi® Network
1. Press and hold the black adjustment button on the garage door opener until 3 beeps are heard (Approximately 6 seconds).
®
Devices from Garage Door Opener

To Open the Door Manually

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs
l
or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
l
NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
l
Disconnect the Trolley
1. The door should be fully closed if possible.
2. Pull down on the emergency release handle so the trolley release arm snaps to
LEARN
the vertical position. The door can now be raised and lowered as often as
Button
necessary.
Adjustment
Button
To Re-Connect the Trolley
1. Pull the emergency release handle toward the garage door opener so the trolley
release arm snaps to the horizontal position. The trolley will reconnect on the next
UP or DOWN operation, either manually or by using the door control or remote
control.
20