Remote Control And Keyless Entry; Homelink - Chamberlain C253 Guide De L'utilisateur

Operation

Remote Control and Keyless Entry

Pre-programmed remote control included, no need to program
the remote.
To add or reprogram a remote control, follow the instructions below. Older
Chamberlain remote controls are NOT compatible.
Program Using the Multi-Function or Motion Detecting Control
Panel
1. Press the LEARN button on the door control to enter Programming
Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control: Press the button on the remote control that you
wish to operate your garage door.
Keyless Entry: Enter a 4-digit personal identification number
(PIN) of your choice on the keyless entry keypad. Then press the
ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when
the code has been programmed. Repeat the steps for programming additional
remote controls or keyless entry devices. If programming is unsuccessful,
repeat the steps using the learn button on the garage door opener.
1 2
The command LED The command LED will
will flash once flash once again.
3
OR
?
Program Using the Smart Control Panel
1. Press the navigation button below "MENU" to view the Features
menu.
2. Use the navigation buttons to scroll to "PROGRAM".
3. Select "REMOTE" or "KEYPAD" to program from the program
menu.
4. Remote Control: Press the button on the remote control that you
wish to operate your garage door.
Keyless Entry: Enter a 4-digit personal identification number
(PIN) of your choice on the keyless entry keypad. Then press the
ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when
the code has been programmed. Repeat the steps for programming additional
remote controls or keyless entry devices. If programming is unsuccessful,
repeat the steps using the learn button on the garage door opener.
1
3
4
? ? ?
PIN
®
2
Press to continue
Press to continue
MYQ WI-FI OPENER
REMOTE
MYQ ACCESSORY
KEYPAD
OR
? ? ? ?
PIN
18
Program Using the Garage Door Opener Learn Button
1. Locate the Learn Button.
2. Press and immediately release the Learn button. The Learn LED
will glow steady for 30 seconds. Within 30 seconds...
3. Remote Control: Press and hold the button on the remote control
that you wish to use.
Keyless Entry: Enter a 4-digit personal identification number
(PIN) of your choice on the keyless entry keypad. Then press and
hold the ENTER button.
Release the button when the garage door opener lights blink or two clicks are
heard. When replacing the light lens cover, ensure the antenna wires are
hanging straight down.
1-2
3
PIN
®

HomeLink

If your vehicle is equipped with HomeLink, a Compatibility Bridge
included) may be necessary for certain vehicles. Visit
bridge.chamberlain.com to find out if a Bridge is needed.
LEARN
Button
LEARN LED
TM (not