Remote Control And Keyless Entry - Chamberlain C610C Manuel Du Propriétaire

Operation
Motion Detecting Control Panel (continued)
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls
while still allowing activation from the door control and keyless entry. This feature is useful for added
peace of mind when the home is empty (i.e. vacation).
Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as
l
long as the lock feature is activated and your handheld remote control will not operate your
door at this time.
Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will
l
stop flashing and normal operation will resume.
TIMER-TO-CLOSE
DO NOT enable TTC if operating a one-piece door. The TTC can be turned on or off and the time
interval can be adjusted to 1, 5, and 10 minute intervals. Once the TTC has been set and the door is
open, the selected close interval will blink and begin to count down to close the door.
Activate: Press and hold the ON button until one of the TTC LEDs light up. Then press the
l
ON button again to cycle through the time interval options (the corresponding TTC LED will
light for each time interval). The garage door opener light bulbs will blink as confirmation.
Deactivate: Press and hold the OFF button until all TTC LEDs turn off and a beep is heard
l
from the motor unit.
Temporarily hold door open (suspend TTC): Press and release the HOLD OPEN button.
l
Press the HOLD OPEN button again to resume normal TTC operation.
PROGRAM
Any compatible remote controls, wireless keyless entry, or MyQ
the garage door opener by pressing the Learn button.
Push Bar
1, 5, and
10 Minute
HOLD OPEN
TTC LED
Button(TTC)
LIGHT Button
Motion Sensor
®
accessories can be programmed to
Motion Sensor Switch
ON (TTC)
Command LED
OFF (TTC)
LEARN Button
LOCK Button

Remote Control and Keyless Entry

Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote
controls are NOT compatible, see page 41 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control: Press the button on the remote control that you wish to operate your garage
door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed.
1
The command LED
will flash once.
3
35
2
The command LED will
flash once again.
OR
? ? ? ?
PIN