Remote Control And Keyless Entry - Chamberlain B503C Manuel Du Propriétaire

Operation
Multi-Function Control Panel (continued)
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls
while still allowing activation from the door control and keyless entry. This feature is useful for added
peace of mind when the home is empty (i.e. vacation).
Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as
l
long as the lock feature is activated and your handheld remote control will not operate your
door at this time.
Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will
l
stop flashing and normal operation will resume.
PROGRAM
Any compatible remote controls, wireless keyless entry, or MyQ
the garage door opener by pressing the Learn button.
Push Bar
LIGHT Button
®
accessories can be programmed to
Command LED
LEARN Button
LOCK Button

Remote Control and Keyless Entry*

Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote
controls are NOT compatible, see page 41 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control: Press the button on the remote control that you wish to operate your garage
door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed.
1
The command LED
will flash once.
3
* Not included with all models.
35
2
The command LED will
flash once again.
OR
? ? ? ?
PIN