Accessories - Scheppach dmt450 Guide D'utilisation

Maintenance
elimination of any malfunctions must only be undertak-
en after turning off the motor.
immediately upon completion of any repair or mainte-
nance work.
when changing tools.
by unscrewing it, cleaned and then sprayed with a dry
lubricant. Grease the threaded spindle.
tool holder and adjust if necessary. In addition, tighten
the hex nut under the bracket.
Problem
Motor doesn't start
b)
c)
Work piece flatters while a)
working
b)
Tool rest or tailstock Setting the eccentric clamping
cannot be clamped
12 english
Trouble shooting
Possible Cause
Defective switch, condenser
Defective extension cord
Working piece becomes loose
while working
Work piece is not properly centered

Accessories

ArticleArt. No.
Screw chuck7400 7200
Socket chuck Ø 30 mm7400 8600
Socket chuck Ø 40 mm7400 7300
Socket chuck Ø 60 mm7400 8700
Driver plate Ø 80 mm7400 8800
Three-jaw chuck Ø 100 mm7400 8900
Four-jaw chuck Ø 125 mm7400 7400
Drill chuck 3 – 16 mm cone mandrel MK-2
Help
a) Check fuse
b) Have an electrician inspect unit
necessary
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
7400 7700