Cleaning Protection Display; Automatic Shut-Off - Gaggenau CI 292 600 Notice D'utilisation

Cleaning protection display

If you wipe over the control panel while the cooktop is
switched on, settings may be changed. To avoid this, the
cooktop has a function you can use to lock the control
panel for cleaning.
Remove the twist knob.
Activating:
An audible signal sounds. The
cooktop settings flash. The heating process is
interrupted. If a cooking timer is programmed, this will
be paused. The control panel is locked for 10 minutes.
You can now wipe over the surface of the control panel
without altering the settings.
Deactivating: Put the twist knob back on within
10 minutes.
The control panel is unlocked. The cooktop reheats to
the previous settings.
To end the function early, put the twist knob back on
before the 10 minutes have elapsed.
−
indicator and the

Automatic shut-off

If an element has been in operation for a longer period
and no settings are changed, the automatic safety
switch-off function is activated.
The element ceases to heat up. A signal sounds and the
œ
residual heat indicator
display.
The element can be selected again at any time and re-
set.
When the automatic safety shut-off is activated depends
on which heat setting has been set (after 1 to 10 hours).
•
or appears on the element
37