For Use With Base And Without Base; Warning - Nuna PIPA NEXT Instructions D'utilisation

For Use with Base and without Base

1
- "i-Size" (Integral Universal ISOFIX Enhanced Child Restraint Systems)
is a category of Enhanced Child Restraint System primarily designed for
use in all i-Size seating position of a vehicle.
2
- According to the UN Regulation No. 129, the Enhanced Child Restraint
with base is a Universal ISOFIX Enhanced Child Restraint and should be
fitted using the ISOFIX connections.
3
- This is an "i-Size" Enhanced Child Restraint System. It is approved
according to UN Regulation No. 129, for use in, i-Size compatible vehicle
seating positions as indicated by vehicle manufacturers in the vehicle
users' manual.
4
- This is an Universal Belted Enhanced Child Restraint System. It is
approved according to UN Regulation No. 129, for use primarily in
"Universal seating positions" as indicated by vehicle manufacturers in
the vehicle user's manual.
5
- If in doubt, consult either the Enhanced Child Restraint System
manufacturer or the retailer.
6
- PIPA next child restraint is compatible with:
PIPA next base
ARRA base
BASE next
Please refer to ARRA instruction manual for the installation of ARRA base.
Please refer to BASE next instruction manual for installation of BASE next.
5
PIPA next instructions

WARNING

Failure to follow these warnings and instructions could result in
serious injury or death.
Any straps holding the infant carrier module to the vehicle should
be tight, that any load leg should be in contact with the vehicle
floor, that any straps restraining the child should be adjusted to the
child's body, and that straps should not be twisted.
After your child is placed in this enhanced child restraint, the safety
belt must be used correctly.
Any luggage or other objects liable to cause injuries in the event of
a collision shall be properly secured.
Be sure that the enhanced child restraint is installed in such a way
that no part of it interferes with movable seats or in the operation of
vehicle doors.
Before carrying the infant carrier module by hand, ensure that
the child is fastened with the child harness, and that the handle is
correctly locked in a vertical position.
Consult the distributor for issues concerning maintenance, repair
and part replacement.
Correct Installation is only permitted by use of the ISOFIX
connectors.
Frequently check the ISOFIX guides for dirt and clean them if
necessary. Reliability can be effected by ingress of dirt, dust, food
particles etc.
Please check before you purchase this enhanced child restraint to
make sure it can be installed properly in your vehicle.
Please keep this enhanced child restraint without a textile cover
away from sunlight, because it may be too hot for child's skin.
Always touch the Enhanced Child Restraint before placing child in
it.
To use this enhanced child restraint with the ISOFIX connections
according to UN Regulation No. 129, your child must meet the
following requirements.
Child height 40cm-83cm/Child weight≤13kg (approximately 15
months old or under).
6
PIPA next instructions