Detach Canopy And Seat Pad; Installation Without Base - Nuna pipa icon Mode D'emploi

Detach Canopy and Seat Pad

1 Detach the snaps to disassemble the canopy, press the button
in the canopy mount and pull the canopy bow out.
2 Pull the fastening pieces underneath the edge of the seat out.
(32)
3 Press the red button to disengage the buckle
the Infant Insert and crotch strap.
4 Detach the elastic band on the head support, and then remove
the head support.
5 Remove the seat pad from the adjustment button as shown in.
(33)
6 Remove the seat pad from the Stroller release button as shown
(34)
in.
25
(31)
(23)
. Remove

Installation without Base

1 DO NOT install this PIPA icon infant child restraint on vehicle
(35)
seats with Lap Belts.
2 This PIPA icon infant child restraint is suitable for vehicle seats
with a 3-point Retractor Safety Belt (without base) only.
3 Place the PIPA icon infant child restraint onto the vehicle seat
where you wish to put it. Pull the vehicle safety belt out and
lock it into the vehicle buckle, sliding the vehicle lap belt into
the side guides of the PIPA icon infant child restraint.
The PIPA icon infant child restraint can not be used if the
vehicle safety belt buckle (female buckle end) is too long
to anchor the PIPA icon infant child restraint securely.
(37)
4 Slide diagonal belt into the rear guide.
5 Pull the vehicle shoulder belt to fasten the PIPA icon infant
child restraint tightly and securely.
6 Level line on carrier must be level to the ground when the PIPA
icon infant child restraint is installed.
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
After installing the PIPA icon infant child restraint, always
check that the vehicle belts are routed correctly and
securely fastened into the vehicle buckle.
(36)
(37)
(38)
(39)
(41)
(40)
26