Contents Of The Box; Handle Adjustment; Installation With Base - Nuna pipa icon Mode D'emploi

Contents of the Box

PIPA icon infant child restraint
Tools Needed: None

Handle Adjustment

1 The handle of the PIPA icon infant child restraint can be
adjusted to 3 positions.
(5)-1
Rocking position.
(5) -2
Baby chair position.
Position for car, hand or stroller transportation.
2 To adjust the handle positon, squeeze handle buttons on both
(6)-1
sides to release it.
3 Rotate handle until it clicks into any of the 3 positions.
19

Installation with Base

1
2
3
4
(5)-3
(6)-2
5
Unfold the load leg from storage compartment.
Fit the ISOFIX guides with the ISOFIX anchor points.
The ISOFIX guides can protect the surface of the vehicle
seat from being torn. They can also guide the ISOFIX
connectors.
Rotate the ISOFIX connectors 180 degrees until they are
pointing in the direction of the ISOFIX guides.
Line up the ISOFIX connectors with the ISOFIX guides, and
then click both ISOFIX connectors into the ISOFIX anchor
(10)
points.
Make sure that both ISOFIX connectors are securely
attached to their ISOFIX anchor points. There should
be two audible clicks and the colors of the indicators
on the both ISOFIX connectors should be completely
(10)-1
green.
Check to make sure the base is securely installed by
pulling on the both ISOFIX connectors.
After placing the base on the vehicle seat, extend the load
(11)
leg to floor . When the load leg indicator shows green
means it is installed correctly, red means it is installed
(11)
incorrectly.
(7)
(8)
(9)
20