Product Use - Nuna cudl clik Mode D'emploi

Product Use

1
- Open the waist band. (1)
2
- Make sure both the shoulder buckles and the side buckles are connected
(circled in green) (2)
3
- Holding the carrier in front of you, slide your arms through the shoulder
straps. (3)
4
- Pull the carrier over your head. (4)
5
- Make sure the yoke is connected (circled in blue). Adjust the height and
width of the yoke vertically and sideways to achieve a comfortable fit. The
yoke should rest between your shoulder blades. (5)
6
- Secure the waist band behind your back, engaging the waist buckle to hold
the band firmly in place. (6)
7
- To adjust the waist band, pull on the webbing to tighten (7), or pull on the
waist band adjuster to loosen (8).
To remove the carrier, reverse the steps above.
DO NOT remove the carrier while your child is in it.
Opening Baby Carrier
1
- Release both shoulder buckles. (9)
2
- Release both side buckles. (10)
3
- The carrier is open. (11)
4
- If your child weighs more than 15 lb (7 kg), the leg hole adjustments are not
needed. Slide the leg hole adjustment button out of the button hole on the
shoulder strap near the side buckle. (12)
Leg hole adjustments MUST be used for children less than 15 lb (7 kg)
to decrease the size of the leg hole and prevent sliding without pinching
or chafing your child's leg.
Magnetic Buckle Indicators
5
- When following the steps for securing your child, secure all four magnetic
buckles by attaching them where you see the
must click into place on the raised indicator area. (13)
11 CUDL™ clik instructions
green indicators. The buckle
Infant Booster
The infant booster MUST be used if your child weighs less than 15 lb (7 kg).
1
- Locate the unzipped infant booster inside the carrier. (14)
2
- Zip the infant booster sides together. (15)
When your child grows out of the infant booster:
3
- Unzip both sides of the infant booster to remove it when it is no longer
needed. (16)
CUDL™ clik instructions 12