Problems, Probable Causes; And Corrective Actions - Krups XP46 Manuel D'utilisation

IFU_KR_XP4600_nafta_NC00026259-01 18/11/11 13:51 Page23
10. PROBLEMS, PROBABLE CAUSES AND
CORRECTIVE ACTIONS
Problems
The espresso
is not hot
enough.
The filter
holder is
locked.
The grounds
are not dry
after water has
run through.
The coffee
flows too
slowly.
The water
does not run
through.
Water leaks
from the filter
holder after an
espresso has
been made.
Possible causes
The cups and the
filter holder are
cold.
You forgot to unlock
the filter.
You have not
tightened the filter
holder properly.
You have tightened
the filter holder too
much.
The ground coffee
is too fine, too oily
or floury.
The filter holder is
dirty.
The water drip-
through grid is
clogged.
No water in the tank.
The tank is not
properly in place.
The filter is clogged.
The ground coffee
is too fine.
Your machine needs
to be descaled.
The dial has not been
returned to the
position.
Your machine needs
to be descaled.
Solutions
Preheat the accessories: cups and
filter holder (see paragraph 5).
Press « » while turning the filter
holder to the left.
Tighten the filter holder by turning it
to the right as far as it will go.
Loosen it slightly.
Choose a larger grind of coffee.
Clean your filter holder (see
paragraph 8).
When the machine has cooled,
clean the brewing head with a
(fig.22)
clean damp cloth
Fill the tank.
Replace the tank in the correct
position.
Clean the filter holder (see Section
8) and try a larger grind of coffee.
Descale the machine (see Section 9).
Turn off your machine by moving the
dial back to the position
Descale the machine (see Section 9).
English
.
(fig.10) .
23