Krups XP46 Manuel D'utilisation page 14

IFU_KR_XP4600_nafta_NC00026259-01 18/11/11 13:51 Page16
English
IMPORTANT: Do not store the filter holder in the locked
position when the machine is not in use to avoid
unnecessary wear to the seal.
W I T H A N " E . S . E . " E S P R E S S O P O D
"ESE" for "Easy Serving Espresso" is a packaged pod (44 mm dia-
meter) of 7g of selected coffee, ground and compacted between
two paper filters, specially designed to make Italian style ristretto
(tight) espressos.
This system allows for simple and clean use of your machine.
n Fill the water tank with fresh cold water to the maximum line and turn
on the machine (fig.1, 2, 3 and 4). The light will flash while the
machine preheats.
n Remove the excess paper from the E.S.E. pod, and place the pod in
the filter holder with the red writing facing down.(fig.6)
n Take care to make sure that the pod is centered in the filter
holder with no paper hanging out, as this may cause leaks and/or
unsatisfactory results.
n Never use more than one pod at a time.
n Then follow the steps above for figure 7-12 to make your espresso.
W I T H A S O F T P O D
Your machine is also compatible with soft pods, which are usually
smaller in diameter than E.S.E. pods. However since soft pods are
not specifically designed for use with espresso machines, you will
get a less flavorful espresso than with an E.S.E. pod.
n Fill the water tank with fresh cold water to the maximum line and turn
on the machine (fig.1, 2, 3 and 4). The light will flash while the
machine preheats.
n Place the soft pod in the filter holder.
n Take care to make sure that the pod is centered in the filter
holder with no paper hanging out, as this may cause leaks and/or
unsatisfactory results.
n Never use more than one pod at a time.
n Then follow the steps above for figure 7-12 to make your espresso.
16