Problems, Probable Causes And Corrective Actions - Krups XP52 AUTOMATIC Mode D'emploi

English
n After 15 minutes, turn the machine back on.
n Make the rest of the water run through into a recipient by pressing the "2 cups" button.
RINSING
IMPORTANT!
After descaling, perform 2-3 rinsing operations with clear water (without espresso
ground coffee), as described in paragraph 4 "USING".
Remember to rinse the steam circuit by following the instructions below:
n Place a container under the steam nozzle.
n Press the "on-off" button.
n Once the "on/off" light stops blinking, turn the knob to the "steam" position (fig.13) and let the water
drain through the nozzle until the steam begins to appear and then return it to the "0" position (fig.15).
The appliance is descaled and ready to be used again.

9. PROBLEMS, PROBABLE CAUSES AND CORRECTIVE ACTIONS

Problems
The espresso is not
hot enough.
The filter holder is
locked.
The grounds are not
dry after water has
run through.
The « on/off », « 1
cup » and « 2 cups »
buttons are flashing
and the machine
does not work.
The coffee flows too
slowly.
The water does not
run through.
11
Possible causes
The cups and the filter
holder are cold.
You forgot to unlock the
filter.
You have not tightened the
filter holder properly.
The knob has been turned
the "steam" position.
The flow rate depends on
the fineness of the coffee
used and can vary when
preparing the espresso
The ground coffee is too
fine, too oily or floury.
The filter holder is dirty.
The water drip-through grid
is clogged.
No water in the tank.
The tank is not properly in
place.
The filter is clogged. The
ground coffee is too fine.
Your machine needs to be
descaled.
The Claris cartridge has been
replaced but not primed
Solutions
Preheat the accessories: cups and filter holder (see
Section 5).
Press "OPEN" while turning the filter holder to the
left.
Tighten the filter holder by turning it to the right as
far as it will go.
Turn the knob to the "0" position (fig.15).
Choose a larger grind of coffee. The perfect
espresso grind will feel like fine grains that do not
clump when pressed together.
Clean your filter holder (see Section 7).
When the machine has cooled, clean the brewing
head with a clean damp cloth (fig.21).
Fill the tank.
Replace the tank in the correct position.
Clean the filter holder (see Section 7) and try a
larger grind of coffee.
Descale the machine (see Section 8).
See paragraph 4.