Problems, Probable Causes And Corrective Actions - Krups XP52 Serie Manuel D'utilisation

11. PROBLEMS, PROBABLE CAUSES AND CORRECTIVE ACTIONS

Problems
The espresso is not The cups and the filter
hot enough. holder are cold.
The filter holder is You forgot to unlock the
blocked filter.
The grounds are not You have not tightened the
dry after water has
filter holder properly.
run through.
The flow rate depends on
the fineness of the coffee
used and can vary when
preparing the espresso
The coffee flows too
The ground coffee is too
slowly.
fine, too oily or floury.
The filter holder is dirty.
The water drip-through grid
is clogged.
No water in the tank.
Tank poorly fitted.
The filter is clogged. The
ground coffee is too fine.
The water does not
Your device is scaled up.
run through.
The Claris cartridge has
been replaced but not
primed.
The switch has not been
Water leaks from the
positioned on the "stop"
filter holder after an
position.
espresso has been
Formation of scale because
made.
of especially hard water.
The filter holder is clogged.
Coffee grounds in
the cup.
The grind is too fine.
The valve at the bottom of
The water tank leaks the tank is dirty or defective.
when it is carried. The valve is blocked by
scale.
Water leaks under
Internal leak.
the appliance.
Water can be present and/or
Water leaks under flow when you remove the
the drip tray drip tray.This is not a sign of
a leak.
Possible causes Solutions
Preheat the accessories: cups and filter holder (see
paragraph 6).
Press "OPEN" while turning the filter holder to the
left.
Tighten the filter holder by turning it to the right as
far as it will go, up to the stop.
Choose a slightly larger grained ground coffee.
Clean your filter holder (see paragraph 8).
When the appliance has cooled, clean the
percolation head with a damp cloth. (fig.21).
Fill the tank.
Press firmly on the tank.
Clean the filter holder (see paragraph 8) and try a
less fine grind.
See paragraph 9.
See paragraph 5.
Turn off your appliance by positioning the switch
on the "stop" position. (fig.9).
Descale the appliance according to the manual
(see paragraph 9).
Clean the filter holder with hot water. Press
"EJECT" to eliminate the remnants of the grounds.
Shake to drain the water.
Choose a slightly larger grind.
Wash the water tank and operate the valve at the
bottom of the tank with your finger.
Descale the appliance (paragraph 9).
Check the position of the tank. If the fault persists,
do not use the appliance, contact an approved
service centre.
English
59