Hi/Low Power Selection (Only In Pmr446 Band) - Midland G9 PLUS Manuel Utilisateur

Deactivating the CTCSS tones:
If you don't want to use the CTCSS tones, follow these steps:
1. Select the desired channel
2. Press the MENU key till the display shows the CTCSS tone blinking on
the left;
3. Select "of" by means of ▲▼.
Activating the DCS codes:
1. Turn on the unit.
2. Select the desired channel by pressing MENU and ▲▼ keys.
Push the MENU button again till the display shows DCS and the tone
3.
code blinks on the right ("of"=no code – default condition).
4. Select the desired DCS code by pushing ▲▼.
5. To confirm the setting, press the PTT or wait for 5 seconds.
Channel P8 with DCS tone 50 (P850) has been set at factory for the "Emer-
gency" function; do not use it for general communications!!
Deactivating the DCS codes:
1. Select the desired channel.
Press the MENU key till the display shows the channel in use and the
2.
DCS code blinks on the right.
3. Select "of" by pushing ▲▼.

Hi/low power selection (only in PMR446 band)

1. To select the power level, press the MENU button till the display shows
Pr.
Use ▲▼ to select L (low power) or H (high power).
2.
To confirm your selection, push PTT or wait for 5 seconds.
3.
When the batteries are fully charged, the high power is 500 mW (ERP), while
the low is 10mW (ERP).
If your radio has to operate within a short range, you can select the low power
and therefore extend the battery life.
On LPD channels (only for G9 Plus Dual band version) the output power is
always 10 mW (ERP).
• PMR446 channels: The selection of high or low power influences the use
of the PTT key. If you choose "H" (high power), by pressing the PTT key,
regardless of what part of it, the transceiver transmit with high power. If
16 | Midland G9/G9E Plus instruction guide