Call Feature; Roger Beep (End Transmission Tone); Keypad Beep - Midland G9 PLUS Manuel Utilisateur

5 7
.
2. Use the ▲▼ buttons to disable or enable this feature (on: enables,
14
oF:disables).
3. Push PTT [11] to confirm or wait for 5 seconds.
20

CALL feature

Midland G9 Plus can send 5 different CALL tones. To send this audio signal to
other users, press the CALL/
21
To select the CALL tones:
22
1. Press MENU, until the display shows "CA" and the active tone code.
23
24
2. By pushing ▲▼ you will hear the 5 pre-set melodies.
3. Confirm by pressing PTT or wait for 5 seconds.
15

ROGER BEEP (End transmission tone)

When the PTT button is released, the radio will beep to confirm to other users
that your transmission has finished.
In the Midland G9 Plus this function is factory disabled.
EMG
CALL
To activate it:
MENU
1. Press the MENU button until the display shows "rb of";
Using the scroll buttons ▲▼ select "on" and "rb on" will be displayed;
2.
3. To confirm the roger beep activation, press PTT or wait for 5 seconds.

Keypad Beep

Everytime a button is pressed, you will hear a beep.
To disable the beeps, follow this procedure:
Press MENU, till the display shows "bP on".
1.
2. Push ▲▼ till "bP of" is displayed.
3. Confirm your selection by pushing PTT or wait for 5 seconds.
In this way, all beeps and tones are disabled.
To enable the keypad beep, repeat this procedure and select "bP on"
18 |
11
9
10
12
13
20
21
22
23
24
15
key.
Midland G9/G9E Plus instruction guide