Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.5 Periodical cleaning
Keep the device dry and clean. Periodical cleaning is recommended. Clean the device every 30-45 days. Switch
the device off before cleaning. Clean the stainless-steel parts and surfaces with warm water and a neutral
detergent, wash them completely and carefully dry them. You may never clean the mentioned surfaces with
aggressive detergents, ordinary steel wool, steel brushes or other sharp objects. This is because ferrous particles
can get stuck on the stainless-steel surfaces, which can cause rust stains. Treat stainless steel parts with stainless-
steel oil. Use a soft cloth with neutral detergent to rub inside. Then use water to remove the detergent. Do not
use a steel brush, metal shovel, etc., as this can damage the fridge. The rack, filter net must be removed and
cleaned with water. To keep the capacitor in a good condition you must keep the filter net clean. Do not use
sharp objects when cleaning the pipes and slats of the evaporator and the condenser.
Please note: Never clean the device with a high-pressure cleaner. Do not pour any water inside to clean the
fridge, this can cause a short circuit.
Warning: Because the fridge is relatively big, do not let kids stay inside, regardless if the product is on or off.
5.6 Maintenance condenser
For a long lifespan and good operation of the device regular maintenance on the condenser is required. The
condenser of the cooling device must be cleaned with a brush or hoover at least every month. Switch the device
off and remove the plug from de wall socket.
Open the compressor compartment by removing the screws behind the white caps, so the condenser is easily
accessible
•
Clean the grid (condenser) with a hoover or brush and do this in the longitudinal direction of the slats
so that the slats are not damaged.
•
Make sure not to damage the wires and cables and do not forget to close the compartment again.
5.7 Long-term out of use
When the device is long-term out of use, you must follow the next procedure:
•
Remove all the food from the device.
•
Switch the device off and remove the plug from the wall socket.
•
Perform all the maintenance work.
•
Leave the doors ajar to avoid any odours.
5.8 Maintenance and solving malfunctions
Repairs and maintenance work not included in this document must always be performed by service technicians
from Combisteel. Overdue maintenance can lead to high repair costs and can void any warranty claims. Do not
perform any maintenance work on the device before the power has been switched off. In such cases remove the
plug from the wall socket. Only use non-aggressive detergents for cleaning the device.
5.9 Malfunctions
If malfunctions occur, always first check the following points before you contact the service technicians:
•
The device is switched on, there is power present on the wall socket.
•
The doors are closed correctly.
•
The device is not standing near a heat source.
•
The condenser is clean and the compressor is functioning.
•
There is no ice on the evaporator.
If the malfunctions continue, remove all good and contact the technical service of Combisteel.
Note: Maintenance must be performed by staff who is authorised thereto. The manufacturer will void all
warranty if non-original parts are used.
www.combisteel.com
9
Publicité
Table des Matières
